Hf
Ok first diy ! Lets this start, if its goes well ill do diy always from what i do!
Tools needed!
*Side cutter plier
*Needle head plier
*Flat head screw driver
*if you use hog rings again (some people use zip ties) you need a hog ring plier and rings
*And lots of patience !
First lets start with rear seats!
You have to remove star screw from the seat belt holder and take it off!
For take off the headrest holder you have pull hard itll come off
And for the lock you have the push the screw driver in from open side and tilt it so it can pop off from the lock!
Last think you have the remove plastic cover off from the back!
Now we can start the remove the cover!
First you have to open the zip
Then open the special plastic seat zip!
And now time to grab the side cutter plier and cut some hog rings! Please be a patient while you removing cover for avoid the rip off your seats!
Now we remove the rear top seats covers off now time to get under seat!
It ll be more easier then the top because it wont be tight as much as tops
You have to flip the rear seat bottom and start cutting the hog rings !
And dont forget any rings between the crack i had 6 ring ! Between each crack!
PS:while you removing this cover from top rear dont forget all the metal clips on plastic ! One of mine still got stuck on the seat i didnt relized it untill almost rip the seat! While i am pulling the cover off!
After removing all the rings , seat cover will be off from the seats :) !
For put the covers back ,you have to grab this bad boy and the ring! and reverse the steps!
And walla!
Sent from my iPhone using Tapatalk
Very nice! This is much cleaner than the last one. Good job, man! Can't wait to see how the front seats come out.
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
Ok! Time to do the fronts!
First we remove the zip and special seat cover clip
And you will see under the seat cover at the back, 2 strap you have to remove that!
And under the seat take the springs out for open up !
I cant believe i dont have picture of bottom [first diy :( ]
So you will see after removing springs at under cover its have another cover holdind bottom seat cove (pull that out from spring)
And then i didnt seperate the seat i just pull the plastic garnish from metal clips little bit and it gave me space the remove the seat plastic clip!
1 long at left side,1 long and 1 small at right side (for driver seat)
And then pull out the bottom seat!
And then pull the seat cover off from buttom make it loose ! And please be patient!
And then this is the most tricky part ! I broke the most of the clips :( you have to pull the clip from back and pushed from top! (Rear side) and open the top clip from top!
And then from back off the seat you will see the springs for remove it! Greens spring you can remove from back! But red ones is hog rings ! You have to cut them!
And buttom part have whole bunch hog rings dont have any spring! Red one is springs and greens is at the bottom seat cover clips need remove to take the seat off
Passenger is ideantical the driver seat!
And putting back the seat covers if you start like this it ll be easyier the put the hog rings on ! Dont pull the cover all the way down ,come down step by step with rings
Sent from my iPhone using Tapatalk
http://www.ephatch.com/forum/showthr...ck-seats/page2
And here is another great diy from fellow ! I believe he explains better then me so itll more support!
Sent from my iPhone using Tapatalk
And here is the some uk rhd seat covers in left hand drive ! I put the right side cover on left side so when you open the door, you cant see the , seat band clip (on shoulder) for rear passengers
Sent from my iPhone using Tapatalk
WOWOWOWOWOWOWWOWWWWW! where can i get me a pair of those seat covers man!? i need it! xD so mush sexy in your ride xD
Its made my car so privacy i love them!
Sent from my iPhone using Tapatalk
omfg man that alot of cash... but i guess i just get mine re appolstered with leather some day and get the type r put in the same spot xD make some replicas of those sexy covers lol
is this a contest submission?
Yes! Please! And i need a change my treat name , i believe i did but it didnt change! If can you change it to (diy seat cover removal , itll be great ) thanks!
only staff can change thread titles once its been posted. i will do it now.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks