nice, thanks for this.
Tools needed:
Soldering Iron
Rosin 60/40
2x 510 Resistors
1x 3mm green LED
1x 3mm clear amber LED
Ebay Fog Switch
Small Drill (about 1/16)
This is a follow up from my old thread:
http://www.ephatch.com/forum/showthread.php?t=44933
tip: you can use hot glue to add a layer of insulation to keep the resistor from touching the switch. Its up to you
Last edited by Danman281; 05-12-2008 at 09:10 PM.
Not a bad fix, but a new OEM switch is only 14$ and a far better choice for most everyone without any electronics experience.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks